Category: Displays

Random Black Screens with nVidia Graphics Card and Windows 7

For several months, I had dealt with an increasingly frustrating issue with my monitor’s screen suddenly going to sleep. Nothing I could do, aside from unplug it from the desktop and plug it back in, could get it to wake up. It certainly wasn’t a monitor issue (though I had those too), as swapping the monitor resulted in the same behavior. It wasn’t a cable issue, nor was it an issue with Windows power settings. I had narrowed it down to single point of failure – driver issues. My NVIDIA driver kept crashing and its frequency was increasing. It went from only happening in games to happening in Office and general browsing.

I had taken some steps to fix this – reverting to old drivers, installing new drivers from a completely clean slate. Nothing worked. Then I found this thread on the EVGA forums. The thread included details that matches my symptoms, down to the event log. According to that thread, it was an issue between the driver series and Windows 7. Even reverting to old drivers didn’t work as I simply hadn’t gone back long enough, as this issue has plagued the driver series for months.

So, I did what any sane person would do – I upgraded to Windows 10.

It has been two weeks now and not a single crash or blip in the event logs about a driver crash.

Now if you are having a similar issue, what do you do? Upgrading to Windows 10 for free ends December 31st, so after that you will need to pay a hefty sum for a license. I wish I can say I have a fix for users still on Windows 7 (aside from going back long enough on the driver history to avoid the bad drivers), but perhaps the thread above will.

Input signal out of range when trying to install windows 10

I had an interesting yet frustrating issue pop up after buying a refurbished dell desktop. I wanted to do a fresh install of Windows 10 on the machine so I hooked it all up. The computer I bought only had integrated intel graphics so that is what I plugged my Dell 2412M (1920 x 1200) monitor into. The computer booted up and I could view the bios just fine, but when I booted to the USB drive to install windows, I ran into a problem.

The windows logo would show and then the dots would circle, then the screen would go black and I would get the error message: “Input Signal Out of Range”. Puzzled, I restarted the computer. I again could see the BIOS followed by the windows logo with the rotating dots. Yet again the monitor went dark and displays the same message as before. (Honesty check: the dell displays a different message than input signal out of range, but my second monitor had that message instead).

So I ran downstairs and grab a spare lower resolution monitor sitting in my garage. I brought it up and plugged it in and into the computer. Same message. Weird. So it isn’t the monitor – it’s the computer. Googling the issue brought me to others having this issue, even trying the steps outlined here: https://www.infopackets.com/news/9901/how-fix-windows-10-display-not-compatible-when-upgrading.

Yet the only real fix I could find was to get a graphics card and hope that solves the issue. This was an unacceptable solution as I had a 24-hour turnaround on this build and I wasn’t in the mood to shop at several stores to try to find a low-wattage low profile graphics card that wouldn’t be sold at rip off prices.

The fix ended up being pretty simple though – when I plugged in the second monitor I didn’t bother to restart the computer – I just did a straight swap. So this time I turned off the computer, swapped the screens, and turned the computer back on. Voila. Success.

This might not fix your problem, after all who else has multiple monitors just sitting around? But maybe there is someone out there who this helps.